TOLL FREE 1-888-919-4440

Catalogue : Prototyping : Surface Mount Protoboards

SchmartBoard® EZ SOIC (0.65mm) Prototyping Shield for Arduino

SchmartBoard® EZ SOIC (0.65mm) Prototyping Shield for Arduino

SKU: 206-0006-02

Bookmark and Share
The SchmartBoard EZ boards make soldering surface-mount components easy! The leads on your component fit into grooves on the SchmartBoard which are already primed with lead-free solder. All you need to do is apply a small amount of water-soluble flux to the component lead and use your soldering iron to melt and push the solder along the groove to the chip leg. This system makes it almost impossible to bridge your connections! Check out the SchmartBoard EZ illustrated guide in the links below.


  • 0.65mm pitch SOIC footprint for prototyping
  • SOT23-6 footprint for prototyping
  • Onboard reset button for the Arduino IC
  • Additional Push-Button switch circuit
  • 5V/GND rail for easy connection
  • 3.3V/GND rail for easy connection
  • 2 General purpose LEDs
  • Optional Pull-up resistors footprints (Through-Hole or SMD) for I2C
  • Spare 0805 footprint x3
  • Surface Mount bypass footprints available on the bottom side